Dialogic SS7G2X Manuel d'utilisateur télécharger pdf (Page 88)

Chapter 6 Command Definitions

6.9.5 MNRSI – Maintenance Restart System Initiate

Synopsis

This command restarts the entire system. All current logon sessions are terminated.

If a software update disk is present, in the CD-ROM drive, then the software update procedure commences.

If no software update disk is present, but a CD containing a configuration dump is present, this configuration

is loaded into memory and the system restarts.

In all other cases, no change to the system configuration occurs and the state of all links is automatically

restored.

If RESET is set to Y, all configuration data is removed.

If SYSTYPE is set, the systems operating mode changes after restart. Possible operation modes are:

• DSC – Digital Signaling Conveter

• SGW – SIGTRAN Signaling Gateway

• SIU – Signaling Interface Unit

Syntax

MNRSI:[RESTART=,][RESET=Y,][SYSTYPE=,];

Prerequisites

• SYSTYPE can only be set to system types that have been licensed for the unit. See the CNSYP command.

Note: SIU is always licensed.

Attributes

PROMPT

Examples

MNRSI;

MNRSI:RESET=Y;

MNRSI:SYSTYPE=SGW;

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 169 170

Pas de commentaire

Dialogic SS7G2X Manuel d'utilisateur Page 88