Dialogic SS7G2X Manuel d'utilisateur télécharger pdf (Page 109)

109

Dialogic

SS7G2x Signaling Server SGW Mode User Manual Issue 4

6.12.5 SGIRI – Signaling Gateway Incoming Route Initiate

Synopsis

This command initiates an incoming route on a Signaling Gateway. The incoming route is selected by the

network and domain (TDM or SIGTRAN) that a data message came from. The network is specified on an SS7

link set on the TDM side and a SIGTRAN link on the SIGTRAN side.

An incoming route can either go directly to a destination or perform analysis of the received message to

determine a destination. If analysis fails, or the destination determined by analysis is not available, the

incoming route can use the destination associated with it as a default destination.

For RKTAB, DEST, NC, and DOMAIN, a value of “null” is supported. “null” indicates a wildcard value and

means any value. “null” is the default value for an RKTAB/DEST entry.

Note: The value “null” cannot be used for these parameters elsewhere in the system unless explicitly

specified in the command.

Syntax

SGIRI:IR=,[NC=,][DOMAIN=,]{[RKTAB=,][DEST=,]}[LABEL=,];

Prerequisites

• If specified, the destination index exists.

• Either an RKTAB or DEST must exist.

• The incoming route does not already exist.

• The NC/DOMAIN combination has not already been specified nor does it form a superset or subset of an

existing NC/DOMAIN combination

Note: This check takes into account one or more routing elements marked as a wild card.

Attributes

CONFIG

Examples

SGIRI:IR=1, DOMAIN=IP,RKI=1;

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 169 170

Pas de commentaire

Dialogic SS7G2X Manuel d'utilisateur Page 109