Dialogic DMG2030DTI Manuel d'utilisateur télécharger pdf (Page 7)

DMG 2000 Series Configuration – Serial Interface

1. Connect the serial cable to the COM 2 connector on the gateway, and connect the other end to the

serial connector on your PC.

2. Using a terminal interface program such as HyperTerminal, create a connection using the

following parameters:

 Baud rate: 115200

 Parity: None

 Data Bits: 8

 Stop Bits: 1

 Hardware Flow Control: Off

3. Select connect.

4. Press the Enter key until the following prompt appears:

PIMG>

5. At the prompt, type pwd and press Enter.

6. When prompted, type the password for the admin user (the default is IpodAdmin) and press

Enter.

7. At the prompt, type quickcfg and press Enter.

8. You are prompted to enter the following parameters:

Client IP Address: Type the IP Address that you want to assign to the media gateway.

Client Subnet Mask: Type the subnet mask that you want to assign to the media gateway.

Default Network Address: Type the IP Address of the default network router.

Select Operating Mode: Type SIP.

Line Mode: Type T1 for a T1 digital link and E1 for an E1 digital link.

Signaling Mode: You can type either CAS or ISDN depending on the type of digital link.

 If you select T1 CAS, you are prompted to select the Loop Start protocol.

 If you select ISDN, you are prompted to specify the T1 protocol to be used.

9. Type Restart at the PIMG> prompt.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Pas de commentaire

Dialogic DMG2030DTI Manuel d'utilisateur Page 7