Dialogic DMG1008MTLDNI Manuel d'utilisateur télécharger pdf (Page 4)

4. Gateway Setup Notes

During the initial setup of the gateway using the serial port, you must:

• Assign the gateway a Unique IP address, subnet mask and network gateway address (if the

latter is required).

• Configure the gateway to use the SIP VoIP protocol.

NOTE: The Mitel gateway is a PBX-specific SKU and therefore does not require being told what

specific PBX it is being configured for.

During the solution-specific setup of the gateway using the web interface, you must:

• Configure the gateway with at least a single IP endpoint pointing to your messaging server. If

multiple IP endpoints are to be used, then ensure they are configured as well.

• Activate fault tolerance and load balancing as required by the application and system

requirements.

• Specify the required audio coders as required by the application.

• Set the hunt group extension number to the extension number you will be using for your

primary DN in the PBX programming.

• Configure the SIP Transport for TCP.

1 2 3 4 5 6 7 8 9 ... 21 22

Pas de commentaire

Dialogic DMG1008MTLDNI Manuel d'utilisateur Page 4