Dialogic 2000 Series Manuel d'utilisateur télécharger pdf (Page 21)

Dialogic Media Gateway

Configuration Note 21 of 32

Default Command File

As mentioned earlier, one of the files downloaded from the Web Service is a Default

Command File. This is a text file that you may desire to edit at some point (note – backup

your edited copy – it will be overwritten the next time you download Current Files from the

Web Service).

There is a unique Command File for each device model. Although the default commands are

currently the same for each gateway, separating them was required to handle any diversion

in the future.

The command files are in the Firmware folder (which is created in the folder that the

application executable is started from). Under the Firmware folder is a folder for each

supported device. The .commands file for each device is in its respective folder.

The table below shows the current commands that are executed on all gateways (Note that

the Page is the page on the xIMG Web Interface where this setting can be manually

changed):

Setting BOOTP Enabled

Value No

5.x Firmware Page

6.x Firmware Page

Notes

Setting this to No speeds up the boot process

Setting Call Connect Mode

Value OnAnswer

5.x Firmware Page

Gateway Advanced

6.x Firmware Page

Deprecated

Notes

Call is considered connected and media is established when voice

is detected or ringback tone cadence is broken on the outbound

PBX call.

Setting Send DNIS to VoIP Endpoint?

Value Yes NOTE: For RS-232 integrated Systems, leave this as NO

5.x Firmware Page

Gateway Advanced

6.x Firmware Page

Deprecated

Notes

Sends the DNIS of inbound calls to Communité in the TO: header.

This provides multi-tenancy support where the TO header is used

to determine the Org, and the DIVERSION header is used to

determine the user or menu.

Setting RTP Digit Relay Mode

Value Inband-Tone

5.x Firmware Page

Gateway Advanced

6.x Firmware Page

VoIP -> Media

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Dialogic 2000 Series Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Passerelles/contrôleurs Dialogic 2000 Series