Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Manuel d'utilisateur télécharger pdf (Page 61)

Configuring IIS for SMTP TLS in Output

To enable the support of TLS on SMTP messages used for notifications (SMTP Gateway output) on the

computer hosting XMediusFAX:

1. Verify if the SMTP Service of IIS is installed and enabled on the computer hosting XMediusFAX:

a) Verify its presence in the Windows Services: Simple Mail Transfer Protocol (SMTP)

b) If the service is not present, install the following Windows component:

• Before Windows 2008: Application Server ➤ Internet Information Services (IIS) ➤ SMTP Service

• From Windows 2008: Turn Windows features on or off ➤ Features ➤ Add Features ➤ SMTP

Server

c) In the Windows Services, access the properties of the SMTP service and set its Startup Type to

Automatic (if it is not already).

Note: Do not start the service now: it must be first configured. If it was already started, you should

stop it now.

2. Configure IIS as TLS output Gateway:

a) Access the Internet Information Services (IIS) Manager.

b) In the left frame of the Manager, expand the host node, right-click the Default SMTP Virtual Server

node and select Rename.

c) Give the node an appropriate name, for example: “Output SMTP Virtual Server”.

d) Right-click again the renamed node and select Properties.

XMediusFAX | Installation and Maintenance Guide 51

Chapter 6 | SMTP Integration

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 101 102

Pas de commentaire

Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Manuel d'utilisateur Page 61